Servicing The Spark Plug - Toro 22280 Operator's Manual

53cm heavy-duty recycler/rear bagger lawn mower
Table of Contents

Advertisement

2.
Shut off the engine and wait for all moving parts
to stop.
3.
Disconnect the wire from the spark plug.
4.
Drain the gasoline from the fuel tank.
5.
Drain the engine oil; refer to
Engine Oil (page
6.
Place a rag under the oil filter
catch any oil that may leak out as you remove
the oil filter.
1. Oil filter
7.
Remove the oil filter.
8.
Use your finger to coat the gasket on the new oil
filter with oil (Figure 26).
1. Gasket
9.
Install the new filter by rotating it clockwise until
the seal contacts the filter housing, then rotate
the filter an additional 3/4 turn by hand.
10.
Fill the crankcase to the Full line on the dipstick
with fresh oil; refer to
(page
9).
11.
Connect the wire to the spark plug.
12.
Run the engine for about 3 minutes.
Changing the
24).
(Figure
Figure 24
Figure 25
4 Adding Oil to the Engine
13.
Stop the engine, wait for all moving parts to stop,
and check for oil leakage around the filter.
14.
Add oil to compensate for the oil in the oil filter.
Refer to
15.
Recycle the used oil filter properly.

Servicing the Spark Plug

24) to
Service Interval: Every 100 hours—Inspect, clean,
Use an NGK BPR5ES spark plug or equivalent.
1.
Shut off the engine and wait for all moving parts
to stop.
2.
Disconnect the wire from the spark plug
8).
3.
Clean around the spark plug.
4.
Remove the spark plug from the cylinder head.
Important:
dirty spark plug. Do not clean the electrodes
g024331
because grit entering the cylinder can
damage the engine.
5.
Set the gap on the plug to 0.76 mm (0.030 inch);
refer to
1. Center-electrode insulator
2. Side electrode
3. Air gap (not to scale)
g002805
6.
Carefully install the spark plug by hand (to avoid
cross threading) until it is hand tight.
7.
Tighten the spark plug to 23 N∙m (2.3 kgf-m, 17
ft-lb).
Important:
very hot and can damage the engine;
overtightening a spark plug may damage the
threads in the cylinder head.
8.
Connect the wire to the spark plug.
25
4 Adding Oil to the Engine (page
and adjust the spark plug gap;
replace the spark plug if necessary.
Replace a cracked, fouled, or
Figure
26.
Figure 26
A loose spark plug can become
9).
(Figure
g000533

Advertisement

Table of Contents
loading

Table of Contents