Page 2
® trademarks owned by the Bluetooth SIG, Inc. and any use of such marks by ZTE Corporation is under license. microSDXC Logo is a trademark of SD-3C, LLC. Other trademarks and trade names are those of their...
Getting to Know Your Phone Earpiece Proximity & light sensor Front camera Indicator light Volume key Power key/ Fingerprint Touch screen sensor Speaker Headset jack nano-SIM/ microSDXC Back cameras card tray Flash Charging/USB Microphone Type-C jack Your phone supports 2.4 GHz and 5 GHz Wi-Fi.
Setting Up Your Phone The nano-SIM card can be installed or removed while the phone is turned on. WARNING! To avoid damage to the phone, do not use any other kind of SIM cards, or any non-standard nano-SIM card cut from a SIM card.
You should fully charge the battery as soon as possible. WARNING! Use only ZTE-approved chargers and USB Type-C cables. The use of unapproved accessories could damage your phone or cause the battery to explode.
2. Connect the charger to a standard AC power outlet. 3. Disconnect the charger when the battery is fully charged. NOTE: If the battery is extremely low, you may be unable to power on the phone even when it is being charged. In this case, try again after charging the phone for at least 20 minutes.
Listening to FM Radio 1. Open FM Radio while the headset is connected. > All channels and select a channel. 2. Touch You can also drag the red needle along the frequency panel or touch to switch to other channels, or touch to adjust the current channel frequency.
Don’t use at gas stations. Your phone may produce a bright or flashing light. Don’t dispose of your phone in fire. Avoid extreme temperatures. Avoid contact with liquids. Keep your phone dry. Do not attempt to disassemble your phone. Only use approved accessories. For pluggable equipment, the socket-outlet shall be installed near the equipment and shall be easily accessible.
Page 9
Display Grant section of www.fcc.gov/oet/ea/fccid after searching on FCC ID: SRQ-ZTEA7040C. The FCC ID also can be found on the device when you open Settings > About phone > FCC For this device, the highest reported SAR value for usage against the head is 1.14 W/kg, and for usage near the...
Page 10
FCC Regulations This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
Page 11
from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.