Connecting Peripheral Equipment - Sharp TL-M4600 Operation Manual

Connecting Peripheral Equipment

Caution
• Be sure to turn off the power and disconnect the plug from the power outlet before connecting/
disconnecting cables. Also, read the manual of the equipment to be connected.
• Be careful not to mix up the input terminal with the output terminal when connecting cables. Mixing up the
input and output terminals may cause malfunctions and other problems.
• After making all connections, turn on the monitor and then the other pieces of equipment. When
connecting a computer, ensure that it is the last equipment to be turned on after all the connections are
made.
• You may need other cables or connectors not listed below.
S-VIDEO IN
VIDEO IN
AUDIO
Equipment
Computer
Note
• Images may not be displayed properly depending on the computer (graphics board) to be connected.
• See page 49 "Computer compatibility chart" for a list of computer signals compatible with the monitor.
Use with computer signals other than those listed may cause some of the functions to not work.
• A Macintosh adaptor may be required for use with some Macintosh computers. Contact your nearest Macintosh Dealer.
• Depending on the computer you are using, an image may not be displayed unless the computer's external output port is
switched on (e.g. Press "Fn" and "F5" keys simultaneously when using a SHARP notebook computer). Refer to the specific
instructions in your computer's operation manual to enable your computer's external output port.
6
COMPUTER IN 
Terminal on connected
equipment
RGB output RGB cable
terminal
RGB output 5 BNC to 15-pin D-sub cable
terminal
DVI digital output DVI Digital cable
terminal
DVI IN
HDMI
COMPUTER IN 
Cable (commercially available)
MONITOR OUT
Terminal on the
monitor
COMPUTER IN 1
COMPUTER IN 2
DVI IN
DVI-D
(HDCP)