Sharp TL-M4600 Operation Manual page 52

Specifications
n Power management
This monitor conforms to VESA DPMS and DVI DMPM. Both your video card and computer must support
the same standard in order for the monitor's power management function to work.
DPMS: Display Power Management Signaling
DPMS Screen Power consumption Hsync Vsync
ON STATE Display
No
STANDBY
display
n DDC (plug and play)
The monitor supports the VESA DDC (Display Data Channel) standard.
DDC is a signal standard for plug and play between monitors and computers. Information about resolution
and other parameters is exchanged between the two. This function can be used if the computer supports
DDC and it has been configured to detect plug-and-play monitors.
There are several types of DDC, depending on the communication method used. This monitor supports
DDCB.
n Connecting pin assignments
DVI-D input terminal: DVI-D 4 pin
RS-232C terminal: D-sub 9 pin
50
3 W (TL-M500)
Yes
78 W (TL-M4600)
.7 W* No
Pin No.


3
4
5
6
7
8
9
0


Pin No.


3
4
5
DMPM: Digital Monitor Power Management
DMPM
Monitor ON
Yes
Active OFF
* When "Standby Mode" is set to "Mode".
No
33 W when "Standby Mode" is set to "Mode".
(TL-M500)
30 W when "Standby Mode" is set to "Mode".
(TL-M4600)
Signal
T.M.D.S data -
T.M.D.S data +
T.M.D.S data /4 shield
Not connected
Not connected
DDC clock
DDC data
Not connected
T.M.D.S data -
T.M.D.S data +
T.M.D.S data /3 shield
Not connected
Signal
Not connected
Received data
Transmitted data
Not connected
GND
Screen Power consumption
3 W (TL-M500)
Display
78 W (TL-M4600)
No display .9 W*
Pin No. Signal
3 Not connected
4 +5 V power
5 GND
6 Hot plug detection
7 T.M.D.S data 0-
8 T.M.D.S data 0+
9 T.M.D.S data 0/5 shield
0 Not connected
 Not connected
 T.M.D.S clock shield
3 T.M.D.S clock+
4 T.M.D.S clock-
Pin No. Signal
6 Not connected
7 Request to Send
8 Clear to Send
9 Not connected