LG LX31 Series Instruction Manual page 29

y If the signal is removed while Auto Sensing (automatic input switch) is enabled, the input returns to the
previous setting.
y If the several inputs are connected by enabling Auto Sensing and the automatic input switch is
performed several times, the input returns to the previous setting only for the last input and does not
repeat the operation for the rest.
y For the AV input connected using the euro scart cable, Auto Sensing does not work for the TV input
because the Auto AV function is enabled.(For other inputs, Auto Sensing works normally.)
7 Forced DVI Audio (* Except for LX54*H, LX53*H series)
y When Forced DVI Audio is selected, the audio signal from the HDMI port will be transmitted through
the RGB, AV, or Audio In #1 component ports.
y The video signal will be transmitted through HDMI to be displayed on the screen in standard quality.
8 Screen Saver Cube
y When 'Screen Saver Cube' is set to 'No', TV will do not display LG Screen Cube.
9 One Channel Map
y If 'One Channel Map' is 'YES', the TV will operate as below.
A. When the TV is auto-scanning, it searches both air and cable channels.
B. In 'Programme Edit' window, all channels are shown in a single list regardless of input source.
(DTV/RADIO/TV) (For satellite supported models, a Satellite input source is also included.)
C. Select the 'Auto Sort' button in the 'Programme Edit' window to sort channels sequentially.
10 DVB-C
y DVB-T/C programmes (channels) are searchable and selectable like following if DVB-C is "Yes".
y
A. Country which uses analog only
- DVB-T(DTV) can be tuned.
VHF : 5 – 12 ( 7M Band)
UHF : 21 – 69 ( 8M Band)
- DVB-C is able to be tuned.
Frequency : 50000 – 858000 ( 8M Band)
B. Country which uses DVB-T(DTV)
- DVB-C is able to be tuned.
Frequency : 50000 – 858000 ( 8M Band)
11 DVB-C Bandwidth (* Only for LX545H series)
y If country is 'Philippines', 'DVB-C Bandwidth' menu will be shown.
y Select the bandwidth of cable tuning.(6Mhz/8Mhz). The default is 6Mhz.
12 RS232 DC Power Outlet (* Only for LX54*H, LX53*H series)
y It is a mode to decide whether to output DC or not for power supply to IB Box in Installation Menu.
We offer a output terminal in one Pin of RS232C Jack for the use of communication.
y 5V DC Power Outlet and 12V DC Power Outlet must operate mutually exclusively. That is, only one of
the two sides must be turned on.
y You can select 'OFF', '5V' or '12V' by pressing < > button.
RS-232C IN
(CONTROL & SERVICE)
CONFIGURATION SETUP
29