Remove the EDP cable
Make sure the following FRUs (CRUs) have been removed.
"Remove the LCD module" on page 44
"Remove the strip cover" on page 46
"Remove the LCD panel" on page 47
Step 1.
Disconnect the EDP cable from the sensor board and then remove the EDP cable.
Figure 38. Remove the EDP cable
Go to
https://support.lenovo.com/partslookup
replacement parts:
EDP cable
Removable tape
Remove the LCD cover
Make sure the following FRUs (CRUs) have been removed.
"Remove the LCD module" on page 44
"Remove the strip cover" on page 46
"Remove the hinge rubbers" on page 46
"Remove the LCD panel" on page 47
"Remove the hinges" on page 48
"Remove the camera privacy shutter" on page 49
"Remove the microphone rubbers" on page 50
"Remove the camera board" on page 50
"Remove the sensor board (with cable)" on page 51
"Remove the EDP cable" on page 52
Go to
https://support.lenovo.com/partslookup
part:
LCD cover
52
Hardware Maintenance Manual
to look up the Lenovo part numbers of the following
to look up the Lenovo part number of the following replacement