Remove The Fingerprint Board With Cable - Lenovo ThinkBook 14s Yoga Gen 3 Hardware Maintenance Manual

Figure 21. Remove the I/O board with cable
Go to
https://support.lenovo.com/partslookup
part:
I/O board with cable

Remove the fingerprint board with cable

Make sure the following FRU (or CRU) has been removed.
"Remove the lower case" on page 30
Step 1. Disconnect the battery pack cable from the system board.
Attention: Use your fingernails to pull the connector to unplug it. Do not pull the cable.
Step 2. Disconnect the I/O board cable from the I/O board and then remove the I/O board. See "Remove
the I/O board with cable" on page 40for details.
Step 3. Remove two screws and then remove the fingerprint board with cable.
Figure 22. Remove the fingerprint board with cable
Screw specifications
M1.6 x L3
to look up the Lenovo part number of the following replacement
Number of screws
2
.
Chapter 4 Removing a FRU or CRU
41