Table of Contents
Advertisement
USER GUIDE
SAFETY • INSTALLATION & INTEGRATION • OPERATING INSTRUCTIONS • MAINTENANCE • SERVICE
Quick Chill
!
CAUTION
A number of zones include a quick chill feature.
Quick chill is designed to quickly pull warm
beverages and foods down to optimum storage
temperature. It is important to only initiate
quick chill modes when the unit has been fully
loaded with warm product. Failure to follow this
notice could result in food or beverages that are
cooled to a point below optimum or frozen.
The following chart lists modes which include the quick
chill feature and the time which quick chill will run.
Mode
Red Wine
White Wine
Sparkling Wine
Beverage/Drinks
Market/Fresh
Root
Pantry
Deli
To initiate quick chill:
1. Press
to select the desired zone, left or right.
2. Press
to select the desired mode setting.
3. Press
until the temperature set point reads "Quick".
The quick chill feature will then begin for the period of
time dictated by the mode type. To cancel quick chill,
simply select a set point other then "quick".
NOTE: There may be a delay before quick chill is
activated. If the opposite zone is currently in a cooling
Run Time
Not Available
1 Hour
1 Hour
4 Hours
4 Hours
1 Hour
4 Hours
5 Hours
cycle while quick chill is selected, the cooling cycle on the
opposite zone will first be completed.
NOTE: Please note, that when quick chill is activated in a
3036, the zone opposite the active quick chill zone will not
return to a cooling cycle until quick chill is complete. If
storing product in the opposite zone it is important to limit
the number of times the door is opened in the zone not
currently under quick chill.
INTERIOR LIGHTING
Your U-Line 3000 Series unit uses a state of the art LED
lighting system. The 3036 model dual zone's lighting can
be independently controlled or set as a group.
Up
Down
1. To begin, press
2. The unit initially defaults to control the lighting in both
Zones simultaneously. To select a single zone press
. Notice the arrows on top of the display changing
state. Pressing
pressing it again will select the right side zone, and
pressing it a third time will select both zones.
3. Press
or
to cycle through each available
brightness setting (Low, Medium or High).
4. Press
to cycle through each available timer setting.
Selections include "On With Door", "On 3 Hours", "On 6
Hours", or "On 24 Hours".
5. To exit, press
or simply wait for the menu to time
out.
22
Zone Toggle
Zone Indicator
Zone Indicator
U-SELECT LIGHTING
LIGHTING
LEVEL
ON WITH DOOR
HIGH
3036 Model Display Shown
U-Select Lighting
to enter the lighting menu.
once will select the left side zone,
Control Operation 3
Select
Power
Advertisement
Table of Contents
Troubleshooting
