Table of Contents
Advertisement
NORMAL COPYING
Power on
16
1
Turn the power switch on.
It will take about 35 seconds for the copier to warm up. However, you
can make desired settings and press the START (
warm-up. Copying will start after warm-up.
If the power is already on and all indicators except the POWER SAVE
indicator are off the copier is in the auto power shut-off mode. Press the
START key in this case. See page 45. POWER SAVE MODES.
2
Place an original face down on the original table, and
align it with the original size scale.
Image loss (max. 5/32" (4 mm)) can occur at the leading and trailing
edges of the copies. Also image loss (max. 5/32" (4 mm) in total) can
occur along the other edges of the copies.
Close the document feeder cover.
3
Ensure that the copy paper size in the paper tray is the
4
same size as the original.
If a tray of the required size is not installed, use the bypass tray and press
the TRAY SELECT (
5
Adjust the copy density.
This copier has three exposure modes to choose from — AUTOMATIC
(
), MANUAL (
Automatic exposure is the standard initial setting for this copier. In this
mode, the characteristics of the original are "read" by the exposure
system and adjustments are automatically made. This optimizes the
contrast of the copied images by reducing the effect of colored or
shaded background areas. See page 30 to adjust the automatic exposure
level.
For manual copy density adjustment, press the AUTO/MANUAL/
PHOTO (
/
adjust with the light (
) key to select the bypass tray.
), and PHOTO (
).
/
) key to select MANUAL (
) and dark (
) keys as desired.
) key during
) and
Advertisement
Table of Contents
