Two-Sided Copying - Sharp AL-1451 Operation Manual

TWO-SIDED COPYING

Two-sided copying can be made on this copier using the manual bypass.
Example: The following two originals will be copied onto two sides of copy paper.
First original
Place the first original on the original table and make a copy.
1
The first copy can be made using either the paper tray or the manual bypass.
Replace the first original with the second original on the original table and close the
2
original cover. Make sure that the first and second originals are oriented in the same
way on the original table.
Both the first and second originals can be set in the SPF but they must be set
separately. If the stream feeding mode for the SPF has been enabled, set the
second original after the SPF ( ) indicator goes out. See page 20.
For tablet binding, turn the first copy over left to right as shown below. For booklet
3
binding, turn the first copy over top to bottom (not shown). Feed the first copy into the
manual bypass. Copying will begin automatically.
Second original
Face up or face down
Face up Face down
3
23