Follett Symphony Plus 110FB425A Operation And Service Manual page 10

VENT
8. Connect molded drain tube to evaporator drain pan, purge solenoid and rear drain fitting.
9. Connect dispenser bin signal cable to two-pin receptacle on the ice machine electrical box
connect the three-pin receptacle to the ice machine electrical box
10. On dispensers equipped with water-cooled ice machines, connect condenser water supply and drain
lines to condenser fittings on ice machine.
11. Turn on water supply and check for leaks.
12. Plug dispenser power cord into 15A rated NEMA 5-15 circuit.
13. If dispenser is equipped with SensorSAFE, remove protective plastic coating from dispense sensor
labels.
14. Turn on power and bin signal rocker switches and test operation.
15. Clean ice machine following instructions in Cleaning section.
16. Remove dispenser hopper access lid and clean dispenser according to instructions.
17. Replace front cover and secure with screws. Installation is complete.
ice level control thermostat
10 110CT425A/W, 110FB425A/W
CLEANING CUP
ICE
NOZZLE
DRAIN PAN
TO DRAIN CUP
0.75" (19 mm)
RESERVOIR FILL
SOLENOID
WATER
RESERVOIR
➋
.
2
1
Hand bend cap tube
end to approximately
45° as shown
45°
WATER SUPPLY
3/8" FPT, 45-90 F (7-32 C)
10-70 PSI (69-483 KPA)
➊
and