Intellimute - Cobra 12 BAND XRS 9630 Operating Instructions Manual

9495 XRS 9630-D-B2 4/10/06
Settings
Your Detector
What to Remember While Using IntelliMute
IntelliMute works with all City and Auto Mute modes.
Whenever engine revs are below the activation point, an arrow
pointing down will appear in the display. Above the activation point,
an arrow pointing up will appear.
Below Activation Point Above Activation Point
N W i h N W i h
If, for any reason, the unit stops sensing your engine's revs,
IntelliMute will indicate an error and automatically turn off.
The rev point you set will be stored in the unit's memory when
power is turned off and recalled each time the power is turned on.
NOTE
The rev point must be reset if you use your detector in a different vehicle.
NOTE
When initially choosing your IntelliMute activation point, a setting
of approximately 300 to 600 RPMs above idle is recommended.
You can reset the activation point at any time to fit your individual
preferences and driving style.
Setting the IntelliMute Activation Point
Your detector must be installed in your vehicle.
CAUTION
Do not attempt to set the rev point while driving.
Your vehicle should be parked and idling.
IntelliMute must be turned on before setting the activation point.
14 English
11:59 AM Page 14
Your Detector
Select/Dim Button
Program/Mute Button
To Set the IntelliMute Activation Point Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode, go to Set

IntelliMute.

Press and release the Set/City button
to begin setting IntelliMute RPMs.
Rev your engine to the level you wish to
set. Rev the engine slightly above idle and
hold revs steady for two seconds.
At the desired rev level, press and
release the Set/City button.
Press and release either the
Select/Dim button to proceed to the
next user mode or the Program/Mute
button to exit the Program mode.
Setting IntelliMute RPMs
Set Intel...
Settings
Tone Visual Display
None Set IntelliMute
Two beeps Press SET at
desired RPMs...
None None
Three beeps IntelliMute Set!
None None
Press SET... Intelli
Mute
Set!
NOTE
If the unit is unable to sense usable pulses within three seconds or if you do not
set a rev point within 20 seconds of beginning these steps, IntelliMute will
indicate an error and automatically turn off.
IntelliMute
Not Set
Tone Visual Display
IntelliMu...
One beep IntelliMute not set
Please try again Please tr...
One beep IntelliMute Off
Nothing Comes Close to a Cobra
Set/City
Button
IntelliMute Off
Intelli
Mute
Off
® 15