Intellimute - Cobra 12 BAND XRS 9530 Operating Instructions Manual

9494- XRS 9530-D-B2 4/10/06
Settings
Your Detector
What to Remember While Using IntelliMute
IntelliMute works with both City and Auto Mute modes.
Whenever engine revs are below the activation point, an arrow
pointing down will appear in the display. Above the activation point,
an arrow pointing up will appear.
Below Activation Point Above Activation Point
i h i h
If, for any reason, the unit stops sensing your engine's revs,
IntelliMute will indicate an error and automatically turn off.
The rev point you set will be stored in the unit's memory when
power is turned off and recalled each time the power is turned on.
NOTE
The rev point must be reset if you use your detector in a different vehicle.
NOTE
When initially choosing your IntelliMute activation point, a setting
of approximately 300 to 600 RPMs above idle is recommended.
You can reset the activation point at any time to fit your individual
preferences and driving style.
Setting the IntelliMute Activation Point
Your detector must be installed in your vehicle.
CAUTION
Do not attempt to set the rev point while driving.
Your vehicle should be parked and idling.
IntelliMute must be turned on before setting the activation point. Depending
on whether the unit is in Tone Alert or Voice Alert mode, you will hear a
series of beeps or voice messages as you follow the steps on page 11.
10 English
11:57 AM Page 10
Your Detector
Hold IntelliMute Button
Press Int...
button ag...
desired RPMs
To Set the IntelliMute Activation Point
Press and hold
the IntelliMute
button for two
seconds.
Rev your engine to
the level you wish
to set (recommend
slightly above idle)
and hold revs steady
for two seconds.
At the desired
rev level, press
and release the
IntelliMute button.
Settings
Rev Level Set
Intelli
Mute
Set!
Tone Voice Visual Display
Two beeps Set Engine Revs Press IntelliMute
button again at
desired RPMs
None None None
Three beeps IntelliMute Set IntelliMute Set!

IntelliMute

NOTE
Not Set
If the unit is unable to sense usable pulses within three
IntelliMu...
seconds or if you do not set a rev point within 20 seconds
of beginning these steps, IntelliMute will indicate an error
Please tr...
and automatically turn off.
IntelliMute Off
Tone Voice
Intelli
Four beeps IntelliMute Not
Set, Please Try
Mute
Again followed by
One beep IntelliMute Off
Off
Nothing Comes Close to a Cobra
IntelliMute Button
Press and hold for
two seconds
Visual Display
IntelliMute not set
Please try again
IntelliMute Off
® 11