Changing The Saw Blade; Use; Switching The Appliance On And Off; Switching The Work Lamp On And Off - Parkside 390483 2201 Translation Of The Original Instructions

Adjusting the workpiece stop
■ During normal operation, the workpiece stop
must be fixed in the lowest position.
♦ If the workpiece stop
sawing, you can undo the workpiece stop
screw to remove it. Use the supplied hex
key to do this. In this way, you can adjust the
workpiece stop
stop in place again using the workpiece stop
screw .

Changing the saw blade

WARNING! RISK OF INJURY!
► Wear protective gloves to avoid injury.
NOTE
► You can reorder saw blades via our service
hotline.
♦ Release the saw blade clamping lever
turning it anticlockwise
♦ Remove the two locking screws
supplied small hex key
protective covers
♦ Carefully remove the saw blade
the guide rollers
page).
♦ Remove any sawdust with a brush or
compressed air.
♦ Slide the saw blade
with the saw teeth pointing upwards. Make sure
that the guide rollers
saw blade .
NOTE
► Make sure that the direction arrow on the
saw blade (if any) is the same as the one
on the rubber wheels
♦ Insert the saw blade
wheels.
■ 8 │ GB │ IE
gets in the way when
upwards. Fix the workpiece
.
with the
. Remove the two
.
. Start at
(see fig. B on the fold-out
into the guide rollers
completely grip the
.
around the two rubber
♦ Retighten
turning it clockwise
♦ Replace the two protective covers
WARNING! RISK OF INJURY!
►
Only operate the appliance with the
protective covers fitted
♦ Perform a test run by briefly switching the
appliance on and off a few times to determine
whether the saw blade is correctly seated.
WARNING! RISK OF INJURY!
► Keep your body away from the sawing
area during the test run!

Use

Switching the appliance on and off
Switching on
by
♦ Hold down the On/Off switch
Switching off
♦ Release the On/Off switch
Switching the work lamp on and off
Switching on
♦ Move the light switch
The work lamp
Switching off
♦ Move the light switch
The work lamp

Setting rotational speed

♦ Adjust the speed setting wheel
between 1 and 6.

Working procedures

♦ Secure the workpiece against slipping, e.g. with
the vice
♦ Use the weight of the saw when sawing.
Do not exert any additional pressure.
♦ Wait until the saw has reached its full speed
before carefully bringing it into contact with the
workpiece.
the saw blade clamping lever
again.
!
.
.
to position I.
lights up.
to position 0.
goes out.
of the saw table.
PMB 1100 B2
by
.
to a position