Install The Cover - Chamberlain LiftMaster CSW200101U Installation Manual

STEP 12

INSTALL THE COVER

The operator cover consists of two pieces: a rear cover and a front cover. The front cover can easily be removed to access the electrical box. To access
the reset switch slide the access door up. The front cover and access door can be locked with the key.
1/2 HP
1. Remove the operator arm from the output shaft by releasing the
handle.
2. Place the rear cover over the operator.
3. Secure both sides of the rear cover to the chassis with the provided
screws.
4. Reattach the operator arm to the output shaft (making sure the pin fits
into the slot) and secure by pushing the handle down.
5. Place the operator arm cover over the operator arm and secure.
6. Align the front cover with the back cover and fit the front cover into
the grooves of the back cover.
7. Secure both sides of the front cover to the chassis with the provided
screws.
TO LOCK THE ACCESS DOOR
From the factory the access door for the reset switch will not be locked.
To lock the access door follow the steps below:
1. Locate the lock tab on the back of the front cover and remove the
screw securing the tab to the cover.
2. Turn the tab 180 degrees, then secure with the screw. The access
door can now be locked.
1 HP
1. Remove the operator arm from the output shaft by releasing the
handle.
2. Place the rear cover over the operator.
3. Secure both sides of the rear cover to the chassis with the provided
screws.
4. Reattach the operator arm to the output shaft (making sure the pin fits
into the slot) and secure by pushing the handle down.
5. Place the operator arm cover over the operator arm and secure.
6. Secure the front cover to the back cover.
INSTALLATION
24
(back of front cover)
Lock Tab
Factory Default position