Advertisement
SLD150
Installation: Ice Machine
Check that gasket tape has been placed at the
outside edge of the dispenser top.
Place corner posts from the carton on top of the
dispenser, at the left and right front corners.
Locate bin thermostat bracket entrance hole, its
found at the right side of the hole in the top of the
dispenser. Make sure the hole is open.
Place the ice machine onto the dispenser. The ice
machine is heavy, use of a mechanical hoist is
recommended.
The ice machine should be tilted up
slightly. Uncoil about 18" of bin
thermostat capillary tube.
Push the end of the capillary tube
thru the plastic tube located to the
left of the compressor.
Observe the tube as it pushes
down out of the base. Adjust the
Plastic Tube
position of the ice machine so that
the capillary tube enters the hole
for the dispenser's bin thermostat
bracket.
Carefully remove cardboard
supports and allow ice machine to
rest on dispenser gasket.
Caution: Bin thermostat capillary
tube must not be kinked or broken
during installation.
Capillary
Bin
Follow all instructions for
Tube
Thermostat
installation of the ice machine.
Bracket In
SLD150
Installation of Bin Thermostat
October 1996
Page 4
Advertisement
