Table of Contents
Advertisement
FOR THE INSTALLER
Installation Limitations:
This ice system is designed to be installed indoors,
in a controlled environment:
Air Temperature
(Not including the remote condenser)
Water Temperature
Water Pressure
Voltage
(Compared to the nameplate)
Operating the machine outside of the limitations is
misuse and can void the warranty.
Scotsman Ice Systems are designed and
manufactured with the highest regard for safety
and performance. They meet or exceed the
standards of UL, NSF, and CSA.
Scotsman assumes no liability or responsibility of
any kind for products manufactured by Scotsman
that have been altered in any way, including the
use of any part and/or other components not
specifically approved by Scotsman.
Scotsman reserves the right to make design
changes and/or improvements at any time.
Specifications and design are subject to change
without notice.
Min.
Max.
0
0
50
F
100
F
0
0
40
F
100
F
20 PSIG
80 PSIG
-5%
+10%
August 1993
Page 3
Location
After uncrating and inspection, the unit is ready for
installation. It is important that the machine be
installed in a location where it has enough space
around it to be accessible for service, usually a
minimum of 6 inches. Try to avoid hot, dirty and
crowded locations. Be sure that the location for the
machine is within the limitations described.
Storage Bin
Tip the storage bin on its back, using parts of the
carton to protect the exterior finish. Install the legs
into the threaded holes in the bottom of the bin.
Turn the leg levelers all the way in preparation for
leveling later. Return the bin to the upright position,
remove paper covering the bin gasket.
Install the bin top according to the directions with
the bin top.
Note: Do not push bin into position, but lift it there.
Pushing a bin, especially one with ice in it, can
cause damage to the legs and the leg mounts.
Ice Maker
The machine is heavy, so the use of a mechanical
lift is recommended for lifting the machine high
enough to install on top of the bin. After the unit is
placed on the bin, line it up so it is even with the
back side. Secure the machine to the bin with the
hardware provided with the machine.
Remove the front panel and remove any shipping
blocks.
Note: Be sure to allow a 6" minimum space
above the top of the machine for service.
NME650R
Advertisement
Table of Contents
