Table of Contents
Advertisement
NME1250R
FOR THE INSTALLER
Location:
After uncrating and inspection, the unit is
ready for installation. It is important that the
machine be installed in a location where it
has enough space around it to be
accessible for service, usually a minimum
of 6 inches. Try to avoid hot, dirty and
crowded locations. Be sure that the
location for the machine is within the
limitations described on page 3.
Storage Bin:
Tip the storage bin on its back, using parts
of the carton to protect the exterior finish.
Install the legs into the threaded holes in
the bottom of the bin. Turn the leg levelers
all the way in preparation for leveling later.
Return the bin to the upright position,
remove paper covering the bin gasket.
Install bin top if required, follow the
directions included with the bin top.
Note: Do not push bin into position, but lift it
there. Pushing a bin, especially one with ice
in it, can cause damage to the legs and the
leg mounts.
Ice Maker:
The machine is heavy, so the use of a
mechanical lift is recommended for lifting
the machine high enough to install on top of
the bin. After the unit is placed on the bin,
line it up so it is even with the back, left,
and right sides. Secure the machine to the
bin with the hardware provided with the
machine.
Remove the front panel and remove the
styrofoam shipping blocks from under the
gearmotor, the top of the ice chute, and
from between the gearmotor and the right
side panel.
FASTEN THE MACHINE
TO THE BIN WITH THE
HARDWARE SUPPLIED
WITH THE ICEMAKER
June 1994
Page 4
LEVEL THE ASSEMBLY
GASKET
Advertisement
Table of Contents
