Utilitech 148003, 0955587 - Utility Pool Cover Pump Quick Start Guide

SEE INSTRUCTION MANUAL FOR COMPLETE DETAILS.

1. Install the snap-on strainer (C) by lining up the pump (A) base to match the strainer. Push down gently until it latches.
   
2. Attach 1-1/4 in. pipe or fitting (not included) to pump (A) discharge, or screw the garden hose adapter/check valve (B) into the pump discharge.
   
   NOTE: Be sure the garden hose adapter/ check valve is installed with the word 'Top' facing up.
3. If using garden hose (not included), thread the female end of the garden hose into the male end of the garden hose adapter (B).
   
   For best performance, unwind the hose before starting the pump.
4. Place pump (A) in an upright position on the pool cover where water will collect. Do not suspend pump (A) by the discharge hose or power cord.
   
   Be sure pump (A) is not sitting in mud, sand, or debris.
5. Plug the pump into a properly grounded, GFCI 115 V outlet. For safety, the pump should always be electrically grounded to a suitable electrical ground, such as a grounded water pipe, properly grounded metallic raceway, or ground wire.
   
6. The pump (A) will turn on when the water level around the pump reaches approximately 2 in. Water must contact the pump sensors in order for it to turn on. When the water level drops to approximately.4 in., pump (A) will run for 10 additional seconds and then turn off.
   

FOR YOUR PROTECTION, ALWAYS DISCONNECT PUMP FROM POWER SOURCE BEFORE HANDLING.