UtiliTech 148007 Utility Transfer Pump Quick Start Guide

1. Pump (A) should be located within 15 ft. of the water source, and strainer (C) should be used at the end of the inlet line. Attach hose adapters (B) and reinforced suction hose (not provided) to pump. Make sure inlet connection is air tight.
NOTE: Regular garden hose should not be used on pump (A) inlet. It will collapse when the pump runs. Hoses that expand and contract will not allow the pump to operate.


Use only rigid pipe or reinforced hose on the pump inlet. Hoses that expand and contract will not allow the pump to operate.

2. Attach discharge hose (not provided) to pump (A) outlet. A standard 3/4 in. garden hose may be used as a discharge line.
CAUTION: Keep the total length as short as possible for best performance.


3.PUMP MUST BE PRIMED BEFORE USING! Remove priming plug from the top of pump (A).
Fill pump (A) housing with clean water. Reinstall plug.
DO NOT RUN DRY.


4. Plug in power cord to grounded outlet. Pump (A) will prime in a few minutes, depending on suction line length.


5. If the pump (A) does not pump water after five minutes, turn off the pump and repeat steps 1 through 3.
DO NOT RUN DRY.