AEG L6TNE621G User Manual page 24

24 www.aeg.com
11.13 Opening the Lid when
the programme operates
CAUTION!
If the temperature and level
of the water in the drum are
too high, the lid lock
indicator
you cannot open the lid.
To open the lid proceed as follows:
1. Press the button On/Off
seconds to deactivate the appliance.
2. Wait for some minutes and then open
carefully the lid.
3. Close the lid.
4. Activate the appliance and set the
programme again.
11.14 Opening the Lid when
the delay start is active
While the delay start operates, the
appliance lid is locked.
To open the appliance lid:
1. Press button Start/Pause
The lid lock indicator
2. Open the appliance lid.
3. Close the lid and press button Start/
Pause
The delay start continues.
11.15 End of cycle
When the programme has finished, the
appliance stops automatically. The
acoustic signal operates (if it is active).
In the display
locked indicator
The indicator of Start/Pause
goes off.
1. Press button On/Off
the appliance.
After five minutes from the end of the
programme, the energy saving function
automatically deactivates the appliance.
stays on and
for some
.
goes off.
.
comes on and the lid
goes off.
button
to deactivate
When you activate the
appliance again, the display
show the end of the last set
programme. Turn the
programme knob to set a
new cycle.
2. Remove the laundry from the
appliance.
3. Make sure that the drum is empty.
4. Keep the door ajar, to prevent mildew
and odours
11.16 Draining water out after
end of cycle
The washing programme is
completed, but there is water in the
drum:
The drum turns regularly to prevent the
creases in the laundry.
The lid lock indicator
stays locked.
You must drain the water to open the lid:
1. If necessary, decrease the spin
speed.
2. Press the Start/Pause
The appliance drains the water and
spins.
3. When the programme is completed
and the door lock indicator
off, you can open the door .
4. Press On/Off
deactivate the appliance.
The appliance drains and
spins automatically after
approximately18 hours.
11.17 AUTO Stand-by option
The AUTO Stand-by function
automatically deactivates the appliance
to decrease the energy consumption
when:
• You do not use the appliance for 5
minutes before you press Start/Pause
button.
Press the button On/Off
the appliance again.
• After 5 minutes from the end of the
washing programme
is on. The lid
button.
goes
some seconds to
to activate