Table of Contents
Advertisement
FME1500R
FOR THE INSTALLER: Final Check List
1. Is the ice system installed indoors
in a location where the air and water
temperatures are controlled, and
where they do not exceed the design
limitations?
2. Is there an electrical service
disconnect within sight of the installed
machine? Has the voltage been
checked, and compared to nameplate
requirements?
3. Have all the plumbing connections
been made and checked for leaks?
4. Has the machine and bin been
leveled?
5. Is there a minimum of 6" clearance
LEVELED?
at the rear, left, and right of the
machine for proper service access
POWER SUPPLY?
and air circulation?
6. Is the water pressure a minimum of
20 psig?
7. Has the machine been secured to
the bin?
8. Is there a water shut off valve
installed near the machine?
9. Is the remote condenser installed
PLUMBING?
per local building codes, and in a
place where it has adequate
ventilation and minimal solar heat
gain?
10. Has all shipping material (under
and next to the gearmotor, and on top
of the ice chute) and literature (inside
the front panel) been removed from
the units?
DRAINS?
11. Have the remote condenser and
precharged lines been properly
installed?
12. Has the electrical connection
between the icemaker and the
condenser been made?
13. Verify that the master switch is in
the OFF position.
14. Switch on the electrical power.
15. Refer to Pre-Start instructions, the
next page.
June 1994
Page 10
Advertisement
Table of Contents
