Un pack your BTR-300 and TR-300 Sys tem. If
there are any dam ages or short ages, re fer to the
"War ranty Ser vice In for ma tion" sec tion in this
man ual.
AN TENNA CON NEC TIONS
The BTR-300 is sup plied with two (2) an ten -
nas. One 5/8-wave an tenna for Trans mit and
one 5/8-wave for Re ceive.
As sem ble the 5/8-wave an tenna by screw ing
the three sec tions into one an other as shown in
Fig ure 8. All three sec tions of the BTR-300
5/8-wave an ten nas must be used. Leaving out a
sec tion will re sult in re duced dis tance ca pa bil -
ity.
Fig ure 8
5/8-wave An tenna As sem bly
EQUIP MENT SET-UP
UN PACKING
AN TENNA IN FOR MA TION
To in sure that the fre quency range of the an ten -
nas match the re ceiver and trans mit ter of the
BTR-300, match the color code on the an tenna
with the color code on the BTR-300.
At tach the an ten nas to the an tenna in put re cep -
ta cles. Tighten the con nec tor se curely.
Attaching 5/8-wave An tenna
-13-
Fig ure 9