Table of Contents
Advertisement
CME1056R
Bin Control: Installation
The bin control is a thermostat. It must be field
installed after the ice machine has been placed on
the bin.
Before starting, remove the front panel and any
baffle in the bin.
1. Locate bin thermostat bulb.
3. Route bulb thru routing tube (located between
the compressor and the reservoir).
4. Locate bin thermostat bracket.
5. Carefully position the thermostat bulb on the
bracket.
6. Fasten the bracket to the bottom of the ice
machine with the two 3-pronged knobs supplied
with the unit.
7. Pull back into the ice machine any excess
capillary tubing.
8. Return the baffle to the bin and continue with
the installation.
Note: If the machine is located at an altitude
higher than 2,000 ft., adjust the thermostat by
removing the plastic cover and rotating the
adjustment screw per the table.
Bin Thermostat Altitude Correction Table
CW Turns of Range Screw (under plastic cover)
Feet
Turns
o
2000
55
4000
160
6000
250
Use This Table to Adjust Thermostat
May 2000
Page 8
Feet
8000
o
9000
o
10000
Turns
o
340
o
385
o
405
Hide quick links:
Advertisement
Table of Contents
