Removal And Replacement: Bin Control Set - Scotsman SCE275 Serivce Manual

Removal and Replacement: Bin Control Set

Bin Controls
The bin controls are located in between the two
evaporators, one on the left and one on the right.
The hood must be removed to gain access to
them.
1. Remove the right front grill.
2. If the machine is making ice, push and release
the Harvest button.
3. After the ice has fallen off the evaporators, push
and hold the Off button until the machine stops.
4. Unplug the machine or disconnect the electrical
power.
5. Remove the two knobs holding the hood to the
bin.
6. Slide the bin forward to remove it from the ice
machine.
7. Locate the bin controls and brackets.
Remove the Mounting Bolt First
Remove Mounting Bolt
January 2003
Page 33
8. Remove the thumb screws holding the bin
controls to the evaporators.
Bin Controls May Have a Shield Over Them
9. Pull the bin controls up and out of the ice
machine.
10. Trace the wires back to the connectors, and
unplug them.
11. Reverse steps 10-1 to replace the bin controls.
Flange of
Bin Control
Note: They MUST be changed as a set.
The bin controls must be positioned so that the
flange of the bin control is behind the water trough.
SCE275
Bin Control
Edge of
Water
Trough