How To Operate The Controller - Scotsman CME1056 User Manual

How To Operate The Controller

The Controller is a microprocessor based device
that receives input from several sources and
switches various components on and off.
Its manual control is thru the use of the Push
Button Control Switches
8
7
6
5
4
3
2
1
1. Freeze Button. Pushing and releasing this
button starts or restarts the machine. The AutoIQ
Controller remembers what cycle it was last in and
returns to that cycle.
2. Harvest Button: Pushing and releasing this
button will cause the machine to go directly to a
Harvest Cycle. Can be done from Freeze or Off.
The machine will switch Off at the end of the
Harvest cycle.
3. Clean Button: Pushing and releasing this
button will cause the machine to empty the
reservoir, refill and leave only the water pump on
for circulation of ice machine cleaner. After the ice
machine cleaner has circulated for about 10
minutes a second push of this button will switch on
the rinsing system to flush out the dissolved scale
and ice machine cleaner.
4. Off Button: Pushing and releasing this button
will switch the machine OFF at the end of the next
cycle. If the button is pushed and HELD for more
than 3 seconds, the unit will switch off
immediately.
9
PUSH BUTTON
CONTROL SWITCHES
INDICATOR LIGHTS:
BIN FULL
FREEZE
HARVEST
CLEAN
OFF
DIAGNOSTIC LIGHTS:
WATER
REFRIGERATION
March 2003
Page 17
To Reset Machine (machine off, error light on):
First push and release the Off button, then push
and release the Freeze button.
Diagnostic Light Recall
To recall the last error on the blue housing CM
controller:
1. Switch the unit OFF by holding the OFF button
for longer than 3 seconds.
2. Hold the Off button down again until the Purge
Setting indicators (Green Lights) are on.
3. Push and release the Harvest button.
The last error code stored in the controller will be
displayed and the purge setting will disappear.
Push the Harvest button again and the
second-to-last error code will be displayed. The bin
full light will also be on to signal that this is the
second-to-last code.
Pushing the Harvest button again will display the
last error code again. Only two error codes are
available for display.
If no error code exists, no code will be displayed
and there will be NO LIGHTS showing.
To return from the display of the last error, do
nothing for 60 seconds or push and hold the Off
button.
After returning from the display of the last error
(Off light glows), the machine may be returned to
the ice making process by pushing and releasing
the Freeze button.
CME1056
3