CME1056
Bin Thermostat: Installation
The bin control is a thermostat. Its bulb must be
deployed after the ice machine has been placed
on the bin or dispenser.
Before starting, remove the left side panel and any
baffle in the bin.
1. Locate bin thermostat bulb.
2. Route bulb thru routing hole (located between
the compressor and the reservoir).
Routing Hole
3. Locate bin thermostat bracket.
4. Carefully position the thermostat bulb on the
bracket.
5. Fasten the bracket to the bottom of the ice
machine with the two 3-pronged knobs supplied
with the unit.
6. Pull back into the ice machine any excess
capillary tubing.
7. Return the baffle to the bin and continue with
the installation.
CW Turns of Range Screw (under plastic cover)
Feet
2000
4000
6000
Insert Tip
May 2000
Page 10
Bin Thermostat Altitude Correction Table
Turns
Feet
o
55
8000
o
160
9000
o
250
10000
Use This Table to Adjust Thermostat
Turns
o
340
o
385
o
405