Cub Cadet 769-11758A Manual page 20

EN
Stopping the device
erator pedal [A] /
standstill.
Switching the cutting mechanism on/off
The PTO switch actuates an mechanical clutch to
switch ON and OFF the cutters.
To switch the cutter deck on, pull the PTO
switch /I.
switch /O.
Adjusting the height of the cutting
mechanism
The cutter deck has a height adjustment mechanism
with multiple height adjustment options for mowing
and a transport position for transport (driving without
mowing).
The cutting height range for mowing is between
approx. 3 cm for the lowest cutting height (notch
index 1) and 12.7 cm for the highest cutting height
(notch index 5).
Set the cutting height range with the notches [D] of
the cutter deck height lock [C] and with the pedal for
the cutter deck height adjustment [A].
You can lock the setting with the locking pin [B].
Each notch equates to a height adjustment of
approx. 6.4 mm.
Setting the cutting height for mowing
Step fully down on the pedal for the cutter deck
height adjustment [A]
Remove the locking pin [B]
the notch for the desired cutting height
cutter deck height adjustment.
Setting the transport position for the cutter
deck
Pull the lever for the cutter deck lock upwards out
of the position
Turn the lever anti-clockwise
into the hole
Step fully down on the pedal [A] for the cutter
deck height adjustment up to the stop
cutter deck height adjustment.
The lever for the cutter deck lock latches into the
hole .
The lever is now locked in the transport position.
20
-
until the device comes to a
.
and re-insert it into
.
[A] slowly for the
.
and insert it
.
.
[A] slowly for the
Releasing the transport position for the cutter
deck
Step fully down on the pedal [A] for the cutter
deck height adjustment up to the stop
Pull the lever for the cutter deck lock upwards out
of the position
Turn the lever anti-clockwise and insert it into the
hole .
cutter deck height adjustment
The cutter deck is now located back in a previ-
ously pinned mowing position.
Note
ing. The V-belt of the cutter deck may
become damaged as a result.
Mowing
CAUTION !
Risk of injury
Only empty the grass catcher when the
Only operate the device with the
Attention !
If the cutters come into contact with a foreign
body (e.g. a stone), or if the device starts
immediately.
Check the device for damage before continuing
operation. In the event of damage, discontinue
use of the device and have it repaired by
a service centre prior to putting back into
operation.
Do not activate the cutter deck in high grass.
Note
The device permits reversing with the cut-
ters switched on (reverse mowing mode).
Exercise particular caution when reversing
with the cutters switched on. Only reverse
with the cutter deck switched on if absolutely
necessary.
so the cut grass is thrown out sideways into the
middle.
Do not allow the grass to grow too long, and never
cut it too short.
Drive in straight lines an do not mow at high speed,
particularly when a mulching kit or grass catcher is
installed.
Operation
.
.
[A] slowly for the
.
-
769-11758A