Table of Contents
Advertisement
14
en | Introduction
2.3
Additional Tools
2.4
Establishing the connection
The unit must have a valid IP address and a compatible subnet mask to operate on your
network. By default, DHCP is pre-set at the factory to On and so your DHCP server assigns an
IP address. With no DHCP server the default address is 192.168.0.1
The Project Assistant app or Configuration Manager (version 7.50 or higher) can be used to
find the IP address. Download the software from https://downloadstore.boschsecurity.com:
1.
2.
3.
If a RADIUS server is used for network access control (802.1x authentication), you must
configure the device before the device can communicate with the network.
To configure the device, connect it directly to a computer using a network cable and then set
the service-level password.
Note:
If you cannot connect, the unit may have reached its maximum number of connections.
Depending on the device and network configuration, each unit can have up to 50 web browser
connections, or up to 100 connections via Bosch Video Client or BVMS.
2.5
Password protection in camera
The device is password-protected. The first time that any user accesses the device, the device
will prompt the user to set a password at the service level.
The camera requires a strong password. Follow the prompts in the dialog box, which specifies
what is required. The system measures the strength of the password that you enter.
Make sure the password obeys these conditions:
–
–
–
–
When you use Configuration Manager to access your device for the first time, you must set the
initial password of the device in Configuration Manager. The Users section (General > Unit
Access > Users) displays the message, "Before you can use this device you have to secure it
with an initial password."
Note: After you set the initial password, a "lock" icon appears next to the device name in the
Devices list in Configuration Manager.
You can also launch the device webpage directly. In the device webpage, an initial password
page appears, displaying input fields and a password strength gauge.
Enter the user name ("service") and a password in the appropriate fields. Refer to the section
User Management for more information.
After a service-level password is set for the device, the device displays a dialog box that
prompts users to enter the user name ("service") and the service-level password every time
that they access the device.
1.
2.
Note: New releases of software may require you to set a new and stronger password.
2022-09 | 2.1 |
Start the web browser.
Enter the IP address of the device as the URL.
During the initial installation, confirm any security questions that show.
8 to 19 characters in length
Upper and lower case letters
Minimum of 1 digit
Minimum of 1 special character
These special characters are not allowed: '@', '&', '<', '>', ':', '+'
Fill in the fields User name and Password.
Click OK. If the password is correct, the desired page appears.
Installation Manual
MIC IP ultra 7100i │ MIC IP starlight 7100i
Bosch Security Systems
Advertisement
Table of Contents
