Steps
1. To remove the dummy metal bracket, insert a star-head screwdriver in the hole of the bracket, push the bracket to release
the bracket, and then lift the bracket out from the system.
NOTE:
Applies if you are upgrading the system that did not have these optional modules.
2. Insert the optional DisplayPort module into its slot from the inside of your computer.
3. Connect the DisplayPort module cable to the connector on the system board .
4. Replace the two (M3X3) screws to secure the optional DisplayPort module to the system.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
HDMI module
Removing optional HDMI module
Prerequisites
1. Follow the procedure in
2. Remove the
side
cover.
114
Removing and installing Field Replaceable Units (FRUs)
after working inside your
before working inside your
computer.
computer.