Table of Contents
Advertisement
3-17. S LOAD GEAR, T LOAD GEAR,
S LOAD LEVER ASSEMBLY AND
T LOAD LEVER ASSEMBLY
(See Figs.3-17-1, 3-17-2 and 3-17-3)
1) Refer to section 3-16 and remove the crescent slide.
2) Refer to section 3-14-2 and remove the S and T incline
mounting assemblies.
3) Remove the clamp
the S load gear
, the S load spring
lever assembly
. When you do this, be careful not to
damage the clamp
Again, be careful when you disassemble the compo-
nents, as the S load spring
4) Remove the following components: the T load
gear
, the T load spring
assembly
. Be careful when you disassemble the
components, as the T load spring
ASSEMBLY NOTES:
1. Apply grease (VHJ-0100) to the shafts
A shown in Fig.3-17-1. Then apply grease (VHJ-0100)
to the parts shown in Fig.3-17-2.
2. When fitting the S load gear
align them in the tape-loaded state, as shown in Fig.
A in Fig.3-17-3. Again, after completing tape-unload-
ing on these gears, check that they are positioned as
shown in Fig. B in Fig.3-17-3, then refer to section 3-
14-2 and fit the S and T incline mounting assemblies.
T load lever
assembly
T load
spring
T load
gear
Parts A
(apply
grease here)
, then remove the components:
and the S load
, which can be damaged easily.
will spring out.
, and the T load lever
will spring out.
,
and parts
and the T load gear
S load spring
S load lever
assembly
Clamp
S load
gear
Shaft
Shaft
Fig.3-17-1
(T side)
Apply grease to the gears
(S side)
Apply
grease here
Fig. A: When tape loading is complete
T load gear
Fig. B: When tape unloading is complete
T load gear
–25–
Apply
grease here
Apply
Apply
grease here
grease inside
the hole
Apply
grease
here
Apply grease inside
the hole
Fig.3-17-2
S load gear
S load gear
Fig.3-17-3
Advertisement
Table of Contents
