Table of Contents
Advertisement
3-10. L GUIDE ACT LEVER ASSEMBLY,
LOAD LEVER ASSEMBLY AND
STOPPER LEVER ASSEMBLY
(See Fig.3-10-1)
1) Refer to section 3-3 and remove the cassette mecha-
nism assembly.
2) Refer to sections 3-9-1 and 3-9-2 ,then remove the
pinch roller lever assembly and the opener mount-
ing.
3) Remove the stopper spring
4) After removing the washer
spring
and the L guide act lever assembly
5) Remove the special nut
assembly
and the L guide lever spring
6) Remove the stopper lever assembly
ASSEMBLY NOTES:
1) Apply grease (VHJ-0100) to the toothed area
L guide act lever assembly
and
.
2) Refer to section 4-3 and adjust the height of the load
lever assembly.
3) Hook the L guide lever spring
and the load lever assembly
4) Put the pin
of the L guide act lever assembly into
the cam groove
of the crescent slide.
Special nut
L guide
lever spring
Washer
L guide
act spring
L guide
act lever
assembly
Stopper
lever assembly
Cam
groove
.
, remove the L guide act
, then remove the load lever
.
.
of the
and around the shafts
into the stopper
shown in Fig. A.
L guide lever spring
Fig. A
Load lever
assembly
Stopper spring
Pin
Shaft
Stopper
Shaft
Fig.3-10-1
3-11. BT LEVER ASSEMBLY
(See Fig.3-11-1)
1) Refer to section 3-2 and remove the mechanism unit.
2) Refer to section 3-3-1 and remove the cassette mecha-
nism assembly.
3) Remove the BT spring
spring
on the underside of mechanism chassis.
4) Remove the clamp
nism chassis, then remove the BT lever assembly
5) Remove the clamp
Then, as shown in Fig. A, align the other end of the
.
band brake assembly with the protruding parts of the
BT lever assembly
ASSEMBLY NOTES:
1. When fitting the BT lever assembly
to bend the stopper
assembly
2. Hook the long hook of the BT spring
lever assembly
4. After assembly, make sure that the mountings on
both ends of the band brake assembly
positioned as shown in Fig. C.
5. After assembly, refer to section 4-2-1, and make the
appropriate adjustment.
Protruding
parts
BT
spring
Fig. D
Sub BT
spring
BT spring
lever
assembly
–18–
, and remove the sub BT
on the underside of the mecha-
on the band brake assembly
before removing it.
or the S incline mounting
out of shape by knocking it against them.
, as shown in Fig. B.
Fig. A
Band brake
Clamp
assembly
Fig. B
Fig. C
Clamp
.
.
, be careful not
into the BT
are
BT lever
assembly
S incline
mounting
assembly
Stopper
Fig.3-11-1
Advertisement
Table of Contents
