Table of Contents
Advertisement
3-3-4.START RACK GEAR AND FRONT RACK GEAR
(See Figs.3-3-5 and 3-3-6)
1) Remove the mechanism unit, referring to section 3-2.
2) Remove the cassette mechanism assembly, referring
to section 3-3-1.
3) Remove the special screw
the front rack gear assembly
it stops, then take it off the shaft
damage the shaft
4) Remove the spring
5) Remove the clamp
remove the start rack gear
ASSEMBLY NOTES:
1. Apply grease (VHJ-0100) to the front rack gear
all over the inside of the groove on the start rack
gear
.
2. Align the positioning mark
with the mark
on the main cam
3. When installing the cassette mechanism assembly,
refer to section 3-3-1 and align the start rack gear with
the pinion gear.
6
Clamp
Start rack gear
(apply grease to
inside of groove)
bk
Positioning mark
9
Main cam
. When you do this, slide
towards the front until
. Take care not to
.
.
on the front rack gear
.
on the front rack gear
.
Front rack gear
(apply grease to
inside of groove)
Shaft
Front rack
gear assembly
Spring
Special screw
FIg.3-3-5
8
Positioning mark
5
Front rack
gear
Fig.3-3-6
3-4. CLEANER ROLLER ASSEMBLY
(See Fig.3-4-1)
1) Remove the clamp
2
. When you do this, be careful not to bend the
plastic springs
2) Remove the clamp
assembly
the cleaner roller assembly
ASSEMBLY NOTES:
1. When mounting the cleaner lever
, then
press the clamp
arrow, and snap it into the mounting
R/P head assembly.
and
B
Plastic spring
–11–
1
and take out the cleaner lever
A
B
and
on the cleaner lever
3
, and take out the cleaner roller
4
. Be careful not to touch the sponge on
4
.
1
in the direction shown by the
4
Cleaner roller assembly
3
Clamp
2
Cleaner lever
1
A
2
.
2
5
on the shaft
,
6
on the audio
Clamp
Plastic spring
5
Shaft
6
Mounting
Fig.3-4-1
Advertisement
Table of Contents
