Quick Start: Getting Up To Speed - Traxxas 69077-4 Owner's Manual

QUICK START: GETTING UP TO SPEED

The following guide is an overview of the procedures for getting your model running. Look for the Quick Start logo on the bottom
corners of Quick Start pages.
1. Read the safety precautions on page 4
For your own safety, understand where carelessness and misuse
could lead to personal injury.
2. Charge the battery pack • See page 13
Fully charge a battery pack (not included). Charge your battery
now so it will be ready when you finish the other setup procedures.
3. Install batteries in the transmitter • See page 13
The transmitter requires 4 AA alkaline or rechargeable batteries
(sold separately).
4. Install battery pack in the model • See page 14
Your model requires a fully charged battery pack (not included).
5. Turn on the radio system • See page 15
Make a habit of turning the transmitter on first and off last.
RAISING AND ADJUSTING THE BODY
the body mount, first remove the 4x10mm countersunk screws that secure the body mount
to the body; then, you may remove the 3mm screws that secure the mount, move the
mount to the position you wish to use, and reinstall the screws. Refer to the exploded
views in your Service and Support Guide for more information.
6. Check servo operation • See page 15
Make sure the steering servo is working correctly.
7. Range test the radio system • See page 15
Follow this procedure to make sure your radio system works properly at
a distance and that there is no interference from outside sources.
8. Drive your model • See pages 18-19
Driving tips and adjustments for your model.
9. Maintain your model • See page 24
Follow these critical steps to maintain the performance of your
model and keep it in excellent running condition.
Your model has a realistic tilt-up body and does not require body clips. To raise the
body for chassis access, reach beneath the front bumper and pull the latch toward the
front of the car and gently lift the body. The rear body pivot has detents and will hold
the body in place. The tightness of the pivots may be adjusted by tightening the pivot
screw using a 2.5mm hex driver.
Note: Over-tightening the pivot
screws will result in premature wear
of the body mount detents.
Front body height can be adjusted by
raising the mount in its holder. To access
The Quick Start Guide is
not intended to replace the
full operating instructions
available in this manual.
Please read this entire
manual for complete
instructions on the proper
use and maintenance of
your model.
Look for the Quick Start
logo at the bottom of
Quick Start pages.
TRAXXAS • 9