Traxxas 69077-4 Owner's Manual page 16

16 • TRAXXAS
TRAXXAS TQ RADIO SYSTEM
i
TQi Binding Instructions
For proper operation, the transmitter and receiver must be
electronically 'bound.' This has been done for you at the factory.
Should you ever need to re-bind the system or bind to an additional
transmitter or receiver, follow these instructions. Note: The receiver
must be powered on for binding and the transmitter and receiver
must be within 5 feet of each other.
1. Press and hold the transmitter's SET button as you switch the
transmitter on. The transmitter's LED will flash red slowly.
2. Press and hold the receiver's LINK button as you switch on the
speed control by plugging a battery into it.
3. When the transmitter and receiver's LEDs turn solid green, the
system is bound and ready for use. Confirm that the steering and
throttle operate properly before driving your model.
Setting up the Antenna
The receiver antenna has been set up
and installed from the factory. The
antenna is secured by a 3x4mm set
screw. To remove the antenna tube,
simply remove the set screw with the
included 1.5mm wrench.
When reinstalling the antenna, slide the
wire into the bottom of the tube until
the white tip of the antenna is at the top of the tube under the black
cap. Next, insert the tube into the mount, making sure the antenna
wire is in the slot in the antenna mount. Install the set screw next to
the antenna tube. Use a 1.5mm wrench to tighten the screw. Do not
over-tighten. Do not bend or kink the antenna wire or shorten the
antenna tube.
Antenna
Tip
Antenna
Tube