Table of Contents
Advertisement
9 Manufacturer's information
9.1 Delivery
● Check that all parts are present and check for any damage
immediately upon receipt.
The product's performance is tested at the factory. The scope
of delivery is apparent from the dispatch documents and the
design from the order number.
9.2 Transport
1. Only transport the product by suitable means. Do not drop.
Handle carefully.
2. After the installation dispose of transport packaging ma-
terial according to relevant local or national disposal regu-
lations / environmental protection laws.
9.3 Storage
1. Store the product free from dust and moisture in its ori-
ginal packaging.
2. Avoid UV rays and direct sunlight.
3. Do not exceed the maximum storage temperature (see
chapter "Technical data").
4. Do not store solvents, chemicals, acids, fuels or similar
fluids in the same room as GEMÜ products and their spare
parts.
10 Installation
Risk of electric shock
▶ There is a danger of injury or death (if
operating voltage is higher than safe
extra low voltage)!
Before performing any work on the
●
GEMÜ product, switch off power and
protect circuit from being switched on
again.
ATEX version
▶ Please observe the relevant EX regulations, in particular
EN 60079-14 and EN 50281-1-12, during installation and
maintenance .
Prior to installation:
1. Check the suitability of the pilot solenoid valve prior to
the installation!
See chapter "Technical data".
www.gemu-group.com
DANGER
NOTICE
10.1 Installation
The equipment is subject to pressure!
▶ Risk of severe injury or death
Depressurize the plant.
●
Completely drain the plant.
●
Installation location:
Do not apply external force to the pilot solenoid valve.
●
- Installation position: Optional.
- Manual override and electrical plug must be accessible.
- Direction of the control medium:
from "P" to "A".
Installation:
- Installation work must only be performed by trained person-
nel.
- Use appropriate protective gear as specified in plant oper-
ator's guidelines.
1. Ensure the suitability of the valve for each respective use.
The valve must be appropriate for the piping system oper-
ating conditions (medium, medium concentration, temper-
ature and pressure) and the prevailing ambient conditions.
Check the technical data of the valve and the materials.
2. Shut off plant or plant component.
3. Secure against recommissioning.
4. Depressurize the plant or plant component.
5. Completely drain the plant or plant component and allow it
to cool down until the temperature is below the media va-
porization temperature and cannot cause scalding.
6. If necessary, correctly decontaminate, rinse and ventilate
the plant or plant component.
7. Carefully remove the caps from the female threads.
10.1.1 Installation - GEMÜ 0326
▶ The GEMÜ 0326 pilot solenoid valve is designed for
mounting as compact valve battery on an aluminium dis-
tributor rail.
▶ On the rear side of the aluminium distributor rail there is
an M4 connection for connecting a potential equalisation
according to ATEX.
11 / 19
10 Installation
WARNING
CAUTION
NOTICE
NOTICE
GEMÜ 0326
Advertisement
Table of Contents
