Safety Certification; Accessories - Sanyo DWM-450 Instruction Manual

This unit is made and tested to meet exacting safety standards.
It meets UL and FCC requirements and complies with safety
performance standards of the U.S. Department of Health and
Human Services.
CAUTION - USE OF CONTROLS OR ADJUSTMENTS OR
PERFORMANCE OF PROCEDURES OTHER THAN THOSE
SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RA-
DIATION EXPOSURE.
THIS UNIT SHOULD NOT BE ADJUSTED OR REPAIRED
BY ANYONE EXCEPT PROPERLY QUALIFIED SERVICE
PERSONNEL.
FCC INFORMATION
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and (2)
this device must accept any interference received, including
interference that may cause undesired operation.
ON OPEN/CLOSE
z q
S L O W
k
PREV S T O P NEXT
f n e
REV P L AY FWD
a
d c
1 2 3
4 5 6
7 8 9
RB-SL50 wireless remote control
P R O G R A M
0
+10
AUDIO SUBTITLE RANDOM Z O O M
SETUP M E N U
ENT
TOP MENU RETURN
REPEAT A - B ANGLE
REMOTE CONTROLLER RB-SL50

SAFETY CERTIFICATION

ACCESSORIES

-E4-
CAUTION:
Changes or modifications not expressly approved by Sanyo
may void the user's authority to operate this equipment.
Note:
This equipment has been tested and found to comply with
the limits for a Class B digital device, pursuant to Part 15 of
the FCC Rules. These limits are designed to provide reason-
able protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in ac-
cordance with the instructions, may cause harmful interfer-
ence to radio communications. However, there is no guaran-
tee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and
receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician
for help.
THIS CLASS B DIGITAL APPARATUS COMPLIES
WITH CANADIAN ICES-003.
CET APPAREIL NUMÉRIQUE DE CLASSE B EST
CONFORME AUX EXIGENCES DU RÉGLEMENT
CANADIEN ICES-003.
Audio/Video cable