Connecting To An Amplifier With Dolby Pro Logic Decoder (Example 6); Power Supply; For Safe And Efficient Operation - Sanyo DWM-450 Instruction Manual

Connecting to an Amplifier with Dolby Pro Logic Decoder (Example 6)

*Audio cable
(not supplied)
To AUDIO OUT jacks
P r Y L
R
P b
C O A X I A L AUDIO OUT S-VIDEO OUT
Note:
Please refer to your amplifier instruction manual.

Power Supply

Connect the power cord to a 120VAC 60Hz outlet. This unit is
equipped with a polarized plug. If you have difficulty inserting
the plug, turn it over and reinsert it. If the unit will not be used
for a long time, disconnect the AC plug from the AC outlet.
Notes:
• Before connecting the power cord to an AC outlet, make
sure that all the connections have been made.
• The unit cannot be entirely disconnected from the AC
power until the power cord is unplugged from the AC outlet.

FOR SAFE AND EFFICIENT OPERATION

• Do not damage the power cord.
• When not in use, disconnect the power cord from the
outlet. Grasp the plug, not the cord, when disconnecting
the unit.
• If water should enter the unit, electrical shock or a mal-
function may result. Use in an area where there is low
humidity and little dust.
• Do not disassemble or alter the unit in any way.
• Do not use the unit in areas where extremes in tempera-
ture occur (below 40˚F (5˚C) or exceeding 95˚F (35˚C)),
or where it may be exposed to direct sunlight.
• Because of the DVD video player extremely low noise
and wide dynamic range, there is a tendency to set the
volume on the amplifier higher than necessary. Doing so
may produce an excessively high output from the ampli-
fier which can cause damage to your speakers. Please
be careful in this regard.
• Sudden changes in the surrounding temperature can
cause dew to form on the optical pickup lens inside the
unit. Under this condition the unit may be unable to oper-
ate properly. If this should occur, remove the disc and
allow the unit to adjust to the surrounding temperature.
Amplifier with Dolby Pro Logic Decoder
To AUDIO INPUT jacks
Front left
speaker
Surround left
speaker
Center
speaker
*Please consult your local audio/video dealer.
CAUTION:
When connecting the DVD video player, follow the instal-
lation instruction in "IMPORTANT SAFETY INSTRUC-
TIONS" on page E2.
CAUTION:
TO PREVENT ELECTRIC SHOCK, MATCH WIDE
BLADE OF PLUG TO WIDE SLOT, FULLY INSERT.
ATTENTION :
POUR ÉVITER LES CHOC ÉLECTRIQUES‚
INTRODUIRE LA LAME LA PLUS LARGE DE LA
FICHE DANS LA BORNE CORRESPONDANTE DE
LA PRISE ET POUSSER JUSQU' AU FOND.
• When carrying the unit, be sure to remove a disc which
may be inside and turn the power off. Then unplug
the power cord from the AC outlet after 10 seconds.
Carrying the unit with a disc inside may damage the
disc and/or the unit.
• The unit is automatically set to the Screen Saver mode
after approximately 5 minutes have elapsed under the stop
or pause mode.
• The unit is automatically set to the standby mode after
approximately 30 minutes have elapsed under the com-
plete stop mode.
• Do not install this equipment in a confined space, such as
a book case or built in cabinet.
Press [q] (or [ q OPEN/CLOSE] on the remote control)
when closing the disc tray. Do not push the disc tray.
-E13-
Front right
speaker
Subwoofer
Surround right
speaker