Advertisement
022552_23661_8820-
00396_F7D4401_v1_Play_Max_Modem_Router_02082010_update_0325-2010-ok
3) Enter your network password (located on your network
information card).
Your wireless device will take a few moments to connect to
your network. If the connection is not made the first time, try
this process again. If you still have difficulty connecting to
your network after trying this process a few times, see the
"Troubleshooting" section in this manual for help with
connecting to your network.
Note: In some cases you may be prompted to select the
security type. It is printed on the card for your convenience.
Using the WPS Button
1) Start WPS Push Button Connection (WPS PBC) on your
computer or other WiFi device that you would like to
connect wirelessly to your Router. Often there will be a
button for this purpose in software that came with the device,
or a physical "WPS," "PBC," or "Security" button on the device
itself.
2) Within two minutes, press the WPS button on your Router.
The WPS light (small light above WPS button) will blink green
while it listens for your WiFi device. Once a connection is
established, the light will turn green and then go out. If a
connection is not established, the light will blink amber. You
may repeat the process to try again.
You can repeat this process for each WPSenabled device you'd
like to add to your network.
Adding USB Devices
[USB INVITATION DIAGRAM (TBD)]
Adding a Drive
You can share a USB hard drive or flash drive to your network via
your Router's USB port. Once connected, you can share files and
music with other computers and devices within your network.
Advertisement
