To Unload a Plot on Roll Media
When you use roll media, the plotter automatically waits until the
required drying time has elapsed before cutting the media and dropping
the plot into the media bin. If you wish to adjust the drying times, refer
to the User's Guide.
To Unload Unused Roll Media
1
Raise the media lever to release the media.
2
Open the roll cover and turn the media stop to wind the media out
of the plotter and onto the roll.
3
Lower the media lever.
Supported Media Sizes and Margin Settings
Media Width (Carriage Axis)
E/A0–size plotter: 190
(7.5 in—36.1 in)
D/A1–size plotter: 190—625 mm
(7.5 in—24.6 in)
Leading and Trailing Edges
Normal: 17 mm (0.67 in)
Smaller (roll media only): 10 mm (0.39 in)
All the above measurements are
(media size minus margins) see User's Guide.
All manuals and user guides at all-guides.com
—
917
mm
2 mm (0.08 in). For plotting area
7
Raise the media lever
Wind the roll
Media Length (Paper Axis)
Roll: 210 mm—15.2 m
(8.3 in—50 ft)
Sheet: 210 mm—1.6 m
(8.3 in—64 in)
Side Margins
5 mm (0.2 in)
5 mm (0.2 in)
1840a