HP DesignJet 750C Plus Quick Reference Manual page 25

I/O setup
Device setup
Continued.....
Localization Note. This table contains the front-panel strings used in the front-panel menus. (All languages except KCT) Use the t
of these supplied for your language. (KCT only) Do not translate table entries. (All) You can adjust column widths slightly and join tw
horizontally adjacent cells if necessary ( already done on in some places). A one–point reduction of the font size can be used if no al
Very similar to 750c UG English except for Sharp lines (added) and Lightness (added).
All manuals and user guides at all-guides.com
MIO (option)
Modular
RS-232-C Config=
Define config
0.5, 1, 2, ...30min
I/O Timeout=
Auto , On, Off,
*
Sharp Lines=
Off , On
Skew tolerance=
On , Off
Cartridge check=
Dark, Normal , Light
Lightness=
Automatic (with
Lang=
PostScript option)
PostScript (option)
HP-GL/2
7586, HP–GL/2
None, Less, Normal , More
Drying time=
Factory
Config A
Config B
Config A Baudrate=
Config B
Factory Parity=
100% , 129%, 141%, 200%, 210%, 2
Scale=
352%, 400%, 419%
Normal , Special
Terminator=
38400, 19
4800, 240
None , Ev
Key:
represents pressing E
Defaults are indicated by
Yellow Shading = Short me
*
Not on DesignJet 700