Wps - Push Button Setup - D-Link DCS-5010L User Manual

Section 2 - Installation

WPS - Push Button Setup

If you have a D-Link Cloud Router and an active mydlink account, the easiest way to create a secure wireless connection is
by using the WPS button on the back of the DCS-5010L. After you complete Step 3 below, you can register your camera with
mydlink. Refer to "Add Your Camera to Your mydlink Account" on page 16.
If you do not have a D-Link Cloud Router, use an Ethernet connect as shown under "Manual Hardware Installation" on page
20. WPS setup only establishes a wireless connection, so in order to use the mydlink features of your camera, you will still
need to run the Camera Setup Wizard (proceed to the next page).
To create a WPS connection:
Step 1
Make sure the camera is plugged in, then press and hold the WPS button on the
back of the camera for ten seconds. The blue WPS status LED will start blinking.
Step 2
Press the WPS button on your router within 60 seconds. The WPS button is
usually on the front or side of your router. If you are not sure where the WPS
button is on your router, please refer to your router's User Manual. On some
routers, you may need to log in to the Web interface and click on an on-screen
button to activate the WPS feature.
Step 3
Allow up top one minute to configure. The DCS-5010L will automatically create
WPS Button
a secure wireless connection to your router. While connecting, the blue LED
will flash and your camera will reboot.
D-Link DCS-5010L User Manual 18