Hanging The Fan - Hunter Sturridge II Installation Manual

1886
5
Slide the adapter cover onto
the downrod until it rests
against the hanger ball.
Pass all wires to one side of horizontal
bar in downrod assembly. Hand tighten
the downrod (at least 4–5 full turns)
until it stops. Trim the wires coming
from the fan so that 8-inches remain
coming from the top of the downrod.
Hunter Pro Tip:
The ground wire attached to the
downrod is approximately 8 inches.
5
Ceiling Bracket Downrod
Installing the Downrod
6
Tighten the setscrew
with pliers. DO NOT
HAND TIGHTEN.
WARNING
FAN FALL HAZARD
To prevent SERIOUS INJURY or DEATH:
• ALWAYS tighten setscrew with pliers.
• DO NOT hand tighten setscrew.
• CHECK the setscrew is tight using pliers
each time you change fan direction.

Hanging the Fan

Hanging Fan Wiring Canopy Blades
7
Lower the adapter cover until it rests flush
against the motor housing.
NOTICE
To prevent damage to fan,
ALWAYS lift holding either the
fan housing or the downrod.
Place the downrod ball into
the slot in the ceiling bracket.
Light Bulbs/Glass Remote Remote Cradle