Responding to the Notification of Upgrade
1 The display shows Upgrade? and two short,
medium- pitched tones sounds every 30 seconds
until the user makes a choice of accepting,
delaying, or rejecting the request
2 Perform one of the following actions:
Press the Menu Select button below Acpt to
•
accept the request to upgrade immediately.
Press the Menu Select button below Dlay to
•
delay the request to upgrade.
Press the Menu Select button below Rej to
•
reject the request to upgrade.
One of the following scenarios occurs:
•
If you choose to accept, the display shows
Programming Dont power off to indicate the
upgrade is about to begin. The radio resets to
install the upgrade. In the case of configuration
data upgrade, this process only takes a few
seconds. In the case of firmware upgrade, the
installation takes several minutes.
154
English
Note
The radio cannot be used while the
upgrade is being installed. Therefore, make
sure to only accept the upgrade at a
convenient time when immediate radio use
is not required.
•
If you choose to delay, a configuration data
upgrade is installed automatically at the next
power up. However, in the case of a firmware
upgrade, the radio prompts Upgrade? again at the
next power up.
•
If you choose to reject, the display shows Upg
Aborted. The radio continues to function with the
current configuration until it gets reprogrammed.
Note
If your radio has problems upgrading over-the-
air, consult a qualified technician for details.
Voice Announcement
This feature enables the radio to audibly indicate the
current feature mode, zone or channel the user has
just assigned. This audio indicator can be customized
per customer requirements. This is typically useful
when the user is in a difficult condition to read the
content shown on the display.