Table of Contents
Advertisement
2-4
Processor and Heatsink Installation
Warning: When handling the processor package, avoid placing direct pressure on the
label area. Also, improper CPU installation and socket/pin misalignment may cause
serious damage to the CPU or the motherboard that will require RMA repairs. Be sure
to read and follow all instructions thoroughly before installing your CPU and heatsink.
Notes:
Always connect the power cord last, and always remove it before adding,
removing, or changing any hardware components. Make sure that you in-
stall the processor into the CPU socket before you install the CPU heatsink.
If you buy a CPU separately, make sure that you use an Intel-certified
multidirectional heatsink only.
Make sure to install the motherboard into the chassis before you install
the CPU heatsink.
If you receive a motherboard without a processor pre-installed, make sure
that the plastic CPU socket cap is in place and that none of the socket
pins are bent; otherwise, contact your retailer immediately.
Refer to the Supermicro website for updates on CPU support.
Installing the LGA2011 Processor
1. There are two load levers on the LGA2011 socket. To open the socket cover,
first press and release the load lever labeled "Open 1st."
1
Note: All graphics, drawings, and pictures shown in this manual are for
illustration only. The components that came with your machine may or may
not look exactly the same as those shown in this manual.
2
Press down on
load lever labeled
"Open 1st"
2-7
Chapter 2: Installation
Advertisement
Table of Contents
