Top Exit - Napoleon B36PTREA-1 Installation And Operation Manual

2.12

top exit

WARNING
!
• Failure to install the cover plate and gasket will cause the appliance to function improperly and can cause
injury or property damage.
Remove the safety barrier and glass door (see "safety barrier & door removal/installation" section).
A.
Remove the contents from the firebox and set aside.
B.
You will need the exhaust and air inlet collar.
To ease assembly, remove the 4 hex head screws,
C.
securing the deflector from inside the top front of the
firebox (Fig. 1).
Remove the outer cover plate and gasket by removing the 4 screws. Install the outer cover plate and
D.
gasket onto the back of the appliance using the 4 previously removed screws (Fig. 2).
Remove the 1 1/2" (38.1mm) thick batt of insulation and discard (Fig. 2).
E.
Place the 7" (177.8mm) intake collar and gasket onto the top of the appliance and secure using 4 screws.
F.
tip:
The screws are packaged in a separate baggie from the manual baggie.
From inside the firebox, install the 4" (101.6mm) exhaust collar with gasket up through the top of the
G.
firebox, and secure with the the 4 hex head 3/4" black screws supplied in the manual baggie (Fig. 3).
note:
Do not overtighten. The gasket needs only to be snug against the firebox.
Reinstall the deflector, glass door, and safety barrier.
H.
COVERPLATE
OUTER
COVERPLATE
OUTER
COVERPLATE
COVERPLATE
GASKET
GASKET
1 1/2" INSULATION BATT
'O' RING
INNER
COVERPLATE
GASKET
1 1/2" INSULATION BATT
1 1/2" INSULATION BATT
OUTER
GASKET
'O' RING
INNER
GASKET
GASKET
OUTER
COVERPLATE
GASKET
COVERPLATE
GASKET
Fig. 2
venting requirements
DEFLECTOR
DÉFLECTEUR
FIG. 2
OUTER
COVERPLATE
OUTER
EN
Fig. 1
EXHAUST
FLUE COLLAR
EXHAUST
FIG. 3
FLUE COLLAR
EXHAUST
FLUE COLLAR
Fig. 3
25
W415-3093 / B / 05.06.22