Volvo S90 2019 Owner's Manual page 655

Fold up the wiper arm when it is in service
position. Service position is activated/
deactivated via the function view in the
centre display when the car is stationary
and the windscreen wipers are not on.
Press the button located on the wiper
blade mounting and pull straight out paral-
lel with the wiper arm.
Slide in the new wiper blade until a "click"
is heard.
3. Check that the blade is firmly installed.
4. Fold the wiper arm back towards the
windscreen.
The wiper blades are different lengths
NOTE
When replacing the wiper blades, note that
they have different lengths. The blade on
the driver's side is longer than on the pas-
senger side.
Related information
Using the rain sensor (p. 180)
•
Using windscreen and headlamp washers
•
(p. 182)
Using the rain sensor's memory function
•
(p. 181)
Filling washer fluid (p. 654)
•
Set the wiper blades in service position
•
(p. 653)
Using windscreen wipers (p. 179)
•
Wiper blades and washer fluid (p. 179)
•
MAINTENANCE AND SERVICE
Set the wiper blades in service
position
In some situations, the windscreen's wiper
blades must be set in service position (verti-
cal position), e.g. when they shall be
replaced.
Wiper blades in service position.
In order to change, clean or lift the wiper
blades (e.g. for scraping off ice from the wind-
screen) they must be in service position.
IMPORTANT
Before placing the wiper blades in the
service position, make sure that they are
not frozen down.
Activating/deactivating service mode
Service mode can be activated/deactivated
when the car is stationary and the windscreen
}}
653