MAINTENANCE AND SERVICE
||
The rectangular section of the clips is aligned in the
longitudinal direction of the car.
5. To remove a clip: Insert a flat object, such
as a table knife or a screwdriver, on the
short sides of the clip so that both of the
clip's lock lugs are pressed in simultane-
ously and then prize/pull out the clip.
636
The hinge's plastic guard is fitted with a plastic rivet
and three latches.
6. To remove the hinge's plastic guard on the
side where the lamp is fitted: Press in the
pin in the centre of the plastic rivet using a
screwdriver or similar: Then pull/prize out
the plastic rivet.
7. After that, open the plastic guard's three
latches using a small screwdriver, for
example, and place the plastic guard to
one side.
8. Carefully pull/fold down the detached part
of the panel in order to access the bulb.
NOTE
Points to remember when the plastic rivet
for the hinge's plastic guard is refitted:
Before you can use the plastic rivet for
•
refitting, you must first press its centre
pin backwards as far as it protrudes
from the plastic rivet.
When the hinge's plastic guard has
•
been fixed in place, press the plastic
rivet into the hole in the plastic guard.
Finally, press the pin into the plastic
•
rivet until the end surface is level with
the surface of the plastic rivet.