Table of Contents
Advertisement
5. To disconnect the battery charger from the mains
socket, pull the plug. Do not pull the cable.
6. Remove the battery from the battery charger.
Note:
Refer to the battery and battery charger
manuals for more information.
Battery information
Refer to the operator's manual of the battery for
information about how to use the battery.
To connect the battery to the product
WARNING:
original batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click.
CAUTION:
move easily into the battery holder, the
battery is not installed correctly. This can
cause damage to the product.
3. Make sure that the battery is installed correctly.
To do before you start the product
1. Examine the work area. Remove objects that can be
thrown out.
2. Examine the cutting attachment. Make sure that the
blades are sharp, and have no cracks and damages.
3. Make sure that the product works correctly. Examine
that all nuts and screws are tight.
4. Make sure that the handle and safety devices are
not damaged and are attached correctly. Do not
operate a product with missing parts or is changed
from its initial specification. Use protective gloves
when it is necessary.
5. Make sure that the covers are not damaged and are
attached correctly, before you operate the product.
12
Only use Husqvarna
If the battery does not
To start the product
1. Push and hold the start/stop button until the green
LED comes on.
2. Push the power trigger to adjust the speed.
To operate the product
•
Start near the ground and move the product up
along the hedge when you cut the sides.
•
Adjust the speed to align with the work load.
•
Make sure that the engine does not touch the hedge.
•
Hold the product near your body for a stable work
position.
•
Make sure that the tip of the cutting equipment does
not touch the ground.
•
Be careful and work slowly until all the branches are
correctly cut.
To adjust the angle of the product
The cutting attachment can be adjusted in 8 different
positions.
1. Remove the battery from the product.
1266 - 003 - 23.09.2022
Advertisement
Table of Contents
