When The Safety Device Is Operating - Baby Lock accomplish 2 Instruction And Reference Manual

Handwheel
Thread is getting tangled.
Doesn't Rotate
Re-thread machine.
Clean bobbin case and under
14-17.25
needle plate. Oil the machine.
Thread Gets
Upper threading is not
threaded correctly.
Tangled on Wrong
Re-thread machine
Side of Fabric
properly.
✽ If you find it difficult to turn the handwheel, you may also see "Sewing Machine Doesn't Run" in "Trouble Shooting".

When the Safety Device is Operating

If a problem persists even after performing the measures in "Sewing Machine Doesn't Run" in "Trouble Shooting",
the machine's safety device may be operating.
Symptom
The machine does not operate.
The indicator lamp blinked for a few seconds.
The machine stopped and will not operate.
The indicator lamp continuously blinks slowly.
✽ The machine will not operate for approximately 1 second immediately after the power is turned on or after
the foot controller pin jack is inserted or removed.
Needle is not attached Needle is bent, or tip is
correctly. dull.
Change needle.
Reattach.
11
Upper thread tension is
Bobbin case may be scratched.
too low.
Remove needle plate and
Increase tension.
15
18
check bobbin case.
The machine is locked because the thread is tangled, etc. Turn off the power,
remove the tangled thread, and clean the machine. (page 25)
Foot controller replacement or machine repair is required. Contact your Baby
Lock retailer.
11
Cause/solution
27